User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 5: Security
4. Do one of the following:
l Edit an existing Firewall Schedule - Right-click an existing Firewall Schedule
and click Edit.
l Add a new Firewall Schedule - Click Add New Schedule below the Available
Firewall Schedules table.
5. Enter a Name to identify the schedule.
The name is shown on the Firewall Rules Configuration page.
6. Set one or more of the Days to On to apply the schedule to the selected days.
7. In the Time of Day field, select the Specific Times radio button to specify during what
time period the schedule will apply.
8. Use the HH, MM, and AM/PM dials to set the schedule Start Time.
This field is visible when the Specific Times radio button is selected.
Note: Place the cursor over a single dial and use the mouse roller to move the
correct number across the black line in the dial.
The selected time populates in the Start Time field.
9. Use the HH, MM, and AM/PM dials to set the schedule End Time.
This field is visible when the Specific Times radio button is selected.
Note: Place the cursor over a single dial and use the mouse roller to move the
correct number across the black line in the dial.
The selected time populates in the End Time field.
10. Click Save to save the changes or Cancel to clear any changes without saving.
Delete a Firewall Schedule
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Security menu, click Firewall > Firewall Schedules.
The defined Firewall Schedules are listed in the table.
4. Right-click the firewall schedule to remove and click Delete.
Note: Right-click anywhere in the table and click Select All > Delete to delete all
the firewall schedules.
5. Click Save to save the changes or Cancel to clear any changes without saving.
Page 106 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.