User's Manual

WavePoint 10e
Note: If Other is selected, enter the IP address in the Other IP address field.
18. Click Save to save the changes or Cancel to clear any changes without saving.
Delete an IPv4 Firewall Rule
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Security menu, click Firewall > IPv4 Firewall Rules.
The defined IPv4 firewall rules are listed in the table.
4. Right click the IPv4 firewall rule to remove and click Delete.
Note: Right-click anywhere in the table and click Select All > Delete to delete all
the IPv4 firewall rules.
5. Click Save to save the changes or Cancel to clear any changes without saving.
Disable an IPv4 Firewall Rule
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Security menu, click Firewall > IPv4 Firewall Rules.
The defined IPv4 firewall rules are listed in the table.
4. Right-click the IPv4 firewall rule to turn off and click Disable.
Note: Right-click anywhere in the table and click Select All > Disable to disable
all the IPv4 firewall rules
5. Click Save to save the changes or Cancel to clear any changes without saving.
Custom Services
While common services use known TCP/UDP/TCP and UDP/ICMP/ICMPv6 ports, many custom or
uncommon applications require traffic to be sent through the firewall. The parameters in this section
allow the traffic type and static ports to be defined for a unique identifier and then create firewall rules
for the user-defined service.
LUM0063AA Rev 05/05/2014 Page 103 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.