User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint™ Product Safety
Default Outbound Policy 99
Set the Outbound Traffic Policy 100
Firewall Rules 100
Creating Firewall Rules for IPv4 100
Delete an IPv4 Firewall Rule 103
Disable an IPv4 Firewall Rule 103
Custom Services 103
Configure Custom Service Settings 104
Delete an Existing Custom Service 104
VPN Passthrough 105
Firewall Schedules 105
Configuring Firewall Schedules 105
Delete a Firewall Schedule 106
Application Rules 107
Configuring Application Rules 107
Delete an Application Rule 108
Application Rules Status 108
VPN Tunnels and IPsec 109
Configuring a VPN Tunnel with IPsec 109
Configuring a Basic VPN Tunnel 109
IPsec Policies 110
Configuring an IPsec VPN Policy 111
Configuring an Auto-policy that uses IKE to Perform Negotiations between Two VPN
Clients 114
Configure Phase 2 Auto Policy Parameters 116
Page 10 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.