Integration Guide

Table Of Contents

MM2 Wireless Data Transceivers

LIM0001AA Rev B (DRAFT)

I installed a new Slave in my network, but I cannot get it to link. The CD light is solid red and the

CTS light is blinking red.

LOS (Line of Sight) issue or settings issue.

I have a site that used to perform flawlessly. Now I cannot reliably get data from the RTU at this site.

Antenna reflected power causing problem. Reflected power may be caused by defects or damage in the

antenna, cabling, connections, etc. Verify that the cabling, connectors, and the antenna are connected

correctly and have not sustained any damage.

When I connect directly to my RTU I am able to poll data successfully. When I add in the

transceivers, I cannot get any data from my poll.

Baud rate above 38,400 may need flow control line connected.

Draft