Installation Guide
Table Of Contents
- About This Installation Guide
- Equipment and Tools Required for Installation
- Transceiver Installation Overview
- Choosing a Location for the Transceiver
- Installing the NEMA Enclosure
- Mounting the Transceiver in the NEMA Enclosure
- Powering the Transceiver
- Configuring the Transceiver
- Approved Antennas
- Installing the Antenna
- Cable Loss and Transmit Power Settings
- Waterproofing External Connections
- Board-Level and DB9 Pinouts
FreeWave Technologies, Inc. products may be subject to control by the Export Administration Regulations
(EAR) and/or the International Traffic in Arms Regulations (ITAR). Export, re-export, or transfer of these
products without required authorization from the U.S. Department of Commerce, Bureau of Industry and
Security, or the U.S. Department of State, Directorate of Defense Trade Controls, as applicable, is prohibited.
Any party exporting, re-exporting, or transferring FreeWave products is responsible for obtaining all
necessary U.S. government authorizations required to ensure compliance with these and other applicable
U.S. laws. Consult with your legal counsel for further guidance.
UL Notifications
Models GX-C, GX-CE, and GX-T are suitable for use in Class 1, Division 2, Groups A, B, C, and D or non-hazardous
locations only. Do not connect or disconnect any connectors while the circuit is live.
Warning! EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS 1, DIVISION 2.
Warning! DO NOT REMOVE OR INSERT THE DIAGNOSTICS CABLE WHILE THE
CIRCUIT IS LIVE.
Input voltage for the models listed above is +6.0 to +30.0 VDC.
Important: Input power shall be derived from a single Class 2 power source.
FCC Notifications
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This
device may not cause harmful interference and 2) this device must accept any interference received, including
interference that may cause undesired operation.
The content of this guide covers FreeWave Technologies, Inc. models sold under FCC ID: KNY-1521131FFF (I2
series) and KNYAMI0032AT (GX family).
All models sold under the FCC ID(s) listed above must be installed professionally and are only approved for use
when installed in devices produced by FreeWave Technologies or third party OEMs with the express written
approval of FreeWave Technologies, Inc. Changes or modifications should not be made to the device.
Warning! The I2 series and GX family transceivers have a maximum transmitted output
power of 500 mW. It is recommended that the transmit antenna be kept at least 20 cm away
from nearby persons to satisfy FCC exposure requirements.
The models described in this guide must be installed in a NEMA enclosure. When any FreeWave Technologies,
Inc. module is placed inside an enclosure, a label must be placed on the outside of the enclosure. The label must
include the text "Contains Transmiiter Module with FCC ID: KNY-1521131FFF (I2 series) and KNYAMI0032AT (GX
family)."
LIG0002AC Rev G iii