Installation Guide

Table Of Contents

2.4 GHz Wireless Data Transceivers

LIG0002AC Rev G

8 - 4-40 x 1/4 inch screws

4 - standoffs

Important: Prior to mounting the bracket to an enclosed transceiver, note the

transceiver's serial number and any other information you might need from the

transceiver's label. After the bracket is attached to the transceiver, the label is no

longer accessible without unscrewing the bracket in its entirety.

After installation, you can retrieve the serial number from the transceiver by reading the

device within ToolSuite or accessing the transceiver's setup menu using a terminal

emulator.

1. Mount with the rail guide slots facing out and the spring loaded guide, into which the rail is inserted,

facing down:

2. For board-level transceivers, place lock washers on all eight of the screws. Attach four of the

standoffs to the flat side of the transceiver with four screws. Align standoffs with the panel holes

and secure with the other four screws.

For enclosed transceivers, place lock washers on four of the screws. Align the bottom enclosure

holes with the panel holes and secure with screws.