Manualshelf

User's Manual

ManualsBrandsFreeWave Technologies ManualsElectronics435-470 MHz License Band Transceiver
31323334353637383940
Spread Spectrum Wireless Data Transceiver User Manual
LUM0002AF Rev E Version 6.3 35
(3)
FREQUENCY ZONE
Frequency Zone allows the user to select which portions of the band the network will use. Setting a zone
to 1 will include it in the hopping pattern, while setting the zone to 0 will exclude that zone. Below is the
frequency zone table displaying the beginning frequency and ending frequency in each of the 16 zones.
Note: The Hop Table Version must be set to 0 (Entire Band) when using Frequency Zones. If another
Hop Table Version were to be selected, the limitations of that selection would be applied to the
hopping pattern as well. For example, if Hop Table Version 3 were selected, only the middle of
the band would be available in the pattern. Then, if Frequency Zones 5, 6, 7, 8 and 9 were set to
0 no allowable frequencies would be available for the radio to use.
Zone Number Beginning Freq. (MHz) Ending Freq. (MHz) Number of Channels per offset
0 2400.3072 2405.4912 5
1 2405.8368 2410.6752 5
2 2411.0208 2415.8592 5
3 2416.2048 2421.0432 5
4 2421.3888 2426.2272 5
5 2426.5728 2431.4112 5
6 2431.7568 2436.5952 5
7 2436.9408 2441.7792 5
8 2442.1248 2446.9632 5
9 2447.3088 2452.1472 5
10 2452.4928 2457.3312 5
11 2457.6768 2462.5152 5
12 2462.8608 2467.6992 5
13 2468.0448 2472.8832 5
14 2473.2288 2478.0672 5
15 2478.4128 2483.2512 5
WARNING: To adhere to the EU specifications, it is necessary to use the proper frequency zone
combination based on the frequency offset. While using a frequency offset of zero, the first
zone (0) needs to be removed. Using frequency offsets of one or two, the last zone (15)
needs to be removed. See table below.
Frequency Offset Frequency Zone Requirements
0 0xxxxxxxxxxxxxxx
1 xxxxxxxxxxxxxxx0
2 xxxxxxxxxxxxxxx0
(4) GOVERNMENT RULES
This section allows the user to set the transceivers to comply with different government standards. Set
the mode to comply with the correct regulations for the area in which the transceiver will be operated. See
2.4GHz Installation Guide for further details.