User's Manual

Spread Spectrum Wireless Data Transceiver User Manual
LUM0002AF Rev E Version 6.3 15
8. Save the HyperTerminal connection settings by selecting Save from the File menu.
IMPORTANT NOTE: Whenever a change is made to the HyperTerminal settings in an open terminal
session, the connection must be disconnected then reconnected before the
settings will take effect.
9. To connect HyperTerminal to the transceiver, press the Setup button on the back of the
FreeWave transceiver. If connected to the diagnostics port, type U (Capital ‘U’) to invoke the
Setup menu.
Model FGR-115WC Model FGR-115RC
(Waterproof) (Rugged)
To invoke the Setup menu in board level radios:
1) Short pins 2 & 4 (Brown to Black) on the white 10 pin header next to the LED’s.
2) If using a Programming Cable (P/N ASC3610Dx), press the Setup button.
3) If using the gray ribbon Diagnostic Cable (P/N AC2009DC), or the black Diagnostic Cable (P/N
AC0409DC),
press Shift-U (capital U) to invoke the Setup menu.
Setup
Button
Setup
Button