User's Manual

FreeWave Technologies User Manual Addendum
421-512 MHz Transceiver
V1.0
LAD0014AA Rev A
2 of 11
• The baud rate of the radio must match the baud rate of the device to which the
radio is attached.
• Press Esc to return to the main menu.
6. Press 3 in the main menu to enter the Radio Characteristics menu.
• The following settings must be the same on all radios throughout the network.
• FreqKey- This setting is discussed later in this manual.
• Max Packet Size-This setting is discussed later in this manual.
• Min Packet Size- This setting is discussed later in this manual.
• RF Data Rate - The LRS Licensed Radio can be configured to operate at one
of two available throughputs. To adjust this setting, press 4, RF Data Rate.
(Available settings are 2 or 3.)
• For Maximum Throughput of 9.6 Kbps at 2 Level GFSK, RF Data Rate= 3.
• For Maximum Throughput of 19.2 Kbps at 4 Level GFSK, RF Data Rate=2.
7. At the Main Menu, press 5.
• Number Repeaters should be set to 0.
• Set the Network ID value to any value between 1 and 4095, except 255.
• Make sure this value is the same on every radio in the network.
Operation in Single Frequency Mode
Note: It is imperative that all transceivers used in a network are set to identical
frequency parameters.
Press 3 in the main menu to enter the Radio Characteristics menu as shown below:
Fig. 1