User's Manual

Table 6. Troubleshooting Guidelines
CONDITION POSSIBLE CAUSE POSSIBLE CORRECTIVE ACTION
Power LED on
SAFECONNECT Belt
Bridge is RED Low SAFECONNECT
batteries Replace Belt Bridge batteries
POWER LED on
SAFECONNECT Belt
Bridge is ORANGE Sirius Wireless Link
battery is low Replace Wireless Link battery
POWER LED on
SAFECONNECT
Belt Bridge is OFF Failure to press the
ON/OFF button for
a full second Press the ON/OFF button until all
three LEDs turn green
Low batteries Replace batteries
Unit inoperative Return unit to factory for repair
COMM LED on
SAFECONNECT
Belt Bridge is ORANGE Absence of Bluetooth
link between Wireless Link
and Belt Bridge Momentarily press the LINK button
while both devices are within range
Reset Wireless Link by pressing
LINK button for five seconds; then,
attempt to establish link
Replace Wireless Link battery and
attempt to establish LINK
Absence of link between
Wireless LINK and
Sirius instrument Wireless Link should be seated or
mated properly with
Sirius instrument in boot
Sirius instrument is OFF Turn instrument ON and wait until
start-up routine is complete and
attempt to establish LINK
COMM LED on
SAFECONNECT
Belt Bridge is RED
(Belt Bridge is not
connected to
SAFESITE network) SAFECOM unit is OFF Turn SAFECOM unit ON
Incorrect network ID
and/or frequency key on
Belt Bridge Return unit to factory for proper
configuration
Belt Bridge out of
network range Belt Bridge will automatically
reconnect when it is in network range
Radio inoperative Return unit to factory for repair
8