User's Manual

FCC Notification

• This radio complies with part 15 of the FCC rules.

• Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including

interference that may cause undesired operation.

• The radio has a maximum transmitted output power of 955 mW.

• The device has been tested and meets the FCC SAR

requirements.

Unpacking the Units

1. Carefully remove components from packing to avoid damaging

sensitive electronic components

2. Search through packing material and inside all containers to

prevent discarding usable or valuable parts.

Getting Started

1. Install the Sirius MultiGas Instrument in the extended rubber boot.

2. Install the Sirius Wireless Link in the provided area at the top of the

instrument.

3. Verify that the SAFECONNECT belt Bridge has a unique device

address to avoid communications conflicts.

By factory default, units are preset in descending order (i.e. 16, 15,

14, 13, etc.) to avoid conflicts with existing systems.

4. Turn ON the Sirius Instrument using the ON/OFF/ACCEPT button

on the unit.

• Wait for the instrument to cycle through the power ON

sequence and diagnostic procedures.

5. Turn ON the SAFECONNECT Wireless Belt Bridge by pressing the

ON/OFF button for approximately one second, until all three LEDs

are green.

6. Observe the power-ON LED sequence; all LEDs are green,

then orange, and then red.

7. Verify that the power LED is green.