User's Manual

FreeWave Technologies Spread Spectrum Transceiver User Manual
900 MHz and 2.4 GHz
V5.0S
10
2. Issue the command ATXC# where # corresponds to the position in the Call
Book where the repeater(s) is/are located
3. Issue the command ATD####### where ####### is the serial number of the
transceiver with which you are attempting a link. The transceiver will link first to
the repeater(s) specified and then to the slave transceiver.
4. If you wish to link to a different slave, this time without using a repeater, it is
imperative that you reissue the ATXC# command. Either:
a) issue the command to a location in the Call Book with no repeaters. In
the Call Book above, for example, this could be ATXC2; or
b) issue the command ATXCA, where A corresponds to All and no
repeaters will be used.
The Slave security may be disabled so that a modem operating as a slave (Modes
1,4, and 6) will connect to any modem calling it regardless of whether the calling
modem is in the slave’s Call Book. This feature is necessary when there are more
than 10 transceivers which may call into a slave and will allow any of the units in
the system to call in. For more information please see Slave Security on page 37.
(7) Point-to-Multipoint Repeater
Setting (7) allows the transceiver to operate as a repeater in a Multipoint network.
Please refer to the next chapter, 'Multipoint Operation', for more information on
running a Multipoint network.
(F) Ethernet options
This menu is only needed for Ethernet modems. Although this menu is included
here, it has nothing to do with the Modem Mode (for example, if the modem mode
is "0", entering "F" doesn't change the Modem Mode to "F"). Please see the
Ethernet addendum for more information on this menu.