User's Manual

FreeWave Technologies Spread Spectrum Transceiver User Manual

900 MHz and 2.4 GHz

V5.0S

Using Mode 6 to call a transceiver not listed in the Call Book

Mode 6 will accept the command ATD####### where ####### is any arbitrary

modem serial number such as 5551234. Upon receipt of this command the

modem will call that modem even though the number is not in the sending

modem’s Call Book.

Using Mode 6 to call a transceiver through one or two repeaters

In conjunction with the ATD command the transceiver may be instructed to use the

repeater(s) specified in the Call Book. This means it is possible to call an

unlimited number of slaves through script files in mode 6 and have up to 10

different repeater combinations.

To call a transceiver through one or two repeaters:

1. The repeaters to be used must first be set up in the Call Book. This would be

done by setting up a number to call (this may be a dummy number) through the

repeater(s) which you wish to use. An example of this is shown below as entries 3

(one repeater) and 4 (two repeaters) in the Call Book.

Figure 3: Using Mode 6 to Call

Through Repeaters