User's Manual

FreeWave Technologies Spread Spectrum Transceiver User Manual
900 MHz and 2.4 GHz
V5.0S
2
Quick Start on a Multipoint System
0) Set Operation Mode
Program one of the units to be a multipoint Master (Operation Mode 2)
Program the Multipoint Slaves (Operation Mode 3)
1) Set Baud Rate
Set the Baud Rate to match the baud rate of the device to which the transceiver
will be connected.
3) Edit Radio Transmission Characteristics
Set FreqKey, Max Packet Size, Min Packet Size, and RF Data Rate to identical
settings on every radio to be used in the network. It is always a good idea to
set the FreqKey, Max Packet Size, Min Packet Size to values other than the
factory defaults.
4) Edit Multipoint Parameters
Will there be a repeater in the network or do you intend to be able to run
diagnostics on the network? If so set that value to 1.
Set the NetworkID to a value between 1 and 4095, other than 255 (enables call
book).
The rest is just fine tuning . . .