User's Manual
Table Of Contents
- FreeWave Technologies
- LRS-455-EU
- Data Transceiver
- Version 1.0, Revision A
- About FreeWave Transceivers
- Choosing a Location for the Transceivers
- Quick Start on a Point-to-Point Network
- Setting up a Transceiver
- Operation Mode
- Baud Rate
- Modbus RTU Timing
- The Modbus RTU setting causes the radio to wait for an amount of time, “gathering” data before sending out the radio link.
- With a setting of 0 (Disabled), the radio will send data out its radio link as soon as the data is received into the serial port.
- With a setting of 1, the radio will wait for a number of slots equal to 2 times the Master Packet Repeat setting before sending the received data out the radio link. For example, if Master Packet Repeat = 3, the radio will wait for 6 slots, gathering ...
- With a setting of 2 and higher, the radio will wait for a number of slots calculated by the following formula:
- (Modbus RTU Setting + Master Packet Repeat Setting + 1) x 2
- For example, in a radio where the Modbus RTU setting = 2 and the Master Packet Repeat setting = 3, the radio will wait for (2+3+1) x 2, or 12 slots.
- Call Book
- Radio Transmission Characteristics
- Edit Radio Transmission Characteristics
- MultiPoint Parameters
- Edit MultiPoint Parameters
- Radio Information
- Operational RS-422 and RS-485 Information
- RS232 Pin Assignments
- RF Board Pinout
- FreeWave Technical Support
- Errata
LRS-455-EU Data Transceiver Users Manual
LUM0032AA Rev A Version 1.0 vii
FACTORY DEFAULT SETTINGS ......................................................................................................................... 23
OPERATIONAL RS-422 AND RS-485 INFORMATION ................................................................................................. 24
RS-422 and RS-485 Full Duplex Pin-Outs .......................................................................................................... 25
RS-485 Half Duplex Pin-Outs ............................................................................................................................. 25
RS232 PIN ASSIGNMENTS ........................................................................................................................................ 25
RF BOARD PINOUT ................................................................................................................................................... 26
FREEWAVE TECHNICAL SUPPORT ............................................................................................................................ 26