Data Sheet

Note: When soldering the connector be very careful not to leave a solder bridge between the
output pads. Doing so will short circuit both the output of the charger and any batteries you
connect to it.
Usage
1. Connect your battery to the output of the charger.
2. Connect a micro USB cable to the input of the charger and connect to a computer USB port, or
connect a mobile phone charger with a micro USB connector.
3. While charging, the orange "Charge" LED will illuminate and the charger will supply up to
the maximum current configured by the current limit jumpers. As the battery approaches full
charge the charger will automatically decrease the current until full charge is reached.
4. When charging is complete, the green "Standby" LED will illuminate and the charger will stop
supplying current to the battery.