User's Manual

WCT- 15W1COILTX User Guide
Freescale Semiconductor 3
the equipment, under the normal charging states, LED D4 will be turned on all the time, and LED D3 will
be blanking, and the RX will powered on the equipment normally.
Figure-3 WCT-15W1COILTX charging the equipment
Others Indicates: when the Transmitter get the end power communication information, it will stop the
charging and wait until the RX is removed, under this state LED D3 will be turned off, and LED D4 will
be turned on all the time. When some fault found, the transmitter will turn off LED D4, and turn on LED
D3 until the fault is removed, fault include the FOD fault, OVP, OTP and so on.
4 Cautions
• This device has been tested and found to comply with the limits pursuant to Part 18 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
• If this equipment does cause harmful interference to other electronic equipments, which can be
determined by turning the equipment OFF and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the equipment
• Increase the separation