Target Interface User Manual

Appendix
MMDS Commands
A–79MMDS0508 Target Interface
A.1.6.3 Description
The LOADMAP command loads a memory map from a file. The file specification
must be the full pathname. If the file is in the current directory, the characters “.\”
must precede the name (for example: LOADMAP .\00123V22.MEM).
Example:
LOADMAP 0xC17
Loads a memory map from a file that matches this MCU identifier (68HC08AX48).
Note that the MCUID identifies an MCU, not an EM Board. The memory map
filename has this format:
0nnnnVvv.MEM
where ‘nnnn’ is the four-digit, hexadecimal ‘MCU-ID’, and ‘vv’ is a two-digit version
number.
MEM
A.1.6.4 Short Description
displays the memory map.
A.1.6.5 Syntax
MEM
A.1.6.6 Description
The MEM command displays the current memory map.
Example:
in>MEM
Type Addresses Comment
-------------------------------------------------------
IO 0.. 3F PRU or TOP TOP board resource or the PRU
NONE 40.. 4F NONE
RAM 50.. 64F RAM
NONE 650.. 7FF NONE
EEPROM 800.. A7F EEPROM
NONE A80..3DFF NONE
Freescale Semiconductor, Inc.
For More Information: www.freescale.com