Target Interface User Manual

Appendix
MMDS Commands
A–77MMDS0508 Target Interface
A.1.4 Target Signal Emulation Commands
SIG
A.1.4.1 Short Description
set emulator signals.
A.1.4.2 Syntax
SIG [[ENABLE] signal {signal}] [ DISABLE signal
{signal}]
signal: The signal to be enabled or disabled: RESETIN or RESETOUT.
ENABLE: Connect the signal from the target system.
DISABLE: Disconnect the signal from the target system.
A.1.4.3 Description
The SIG command enables or disables control signals from the target MCU. If the
command specifies any signals, but lacks either keyword ENABLE nor DISABLE, the
command enables the signals.
Example:
SIG ENABLE RESETIN
Enables the “reset in” signal from the target system.
A.1.5 Reset Commands
RESET
A.1.5.1 Short Description
resets target MCU.
Freescale Semiconductor, Inc.
For More Information: www.freescale.com