Target Interface User Manual

Appendix
MMDS Commands
A–60
MMDS0508 Target Interface
Without a rate value, the command displays the Communications Baud Rate
Specification dialog box for interactive rate selection. If the system does not support
the requested rate, the red message, “Error: <baud rate> is not a supported baud rate.”
appears in the Command Line window.
Example:
BAUD 57600
Changes the Baud Rate Command
to 57600.
A.1.2 Trigger Commands
CT
A.1.2.1 Short Description
clear triggers.
A.1.2.2 Syntax
CT list | *
list: A list of trigger identifiers (A, B, C, or D).
*: All triggers.
A.1.2.3 Description
The CT command clears definition values of specified bus analyzer triggers (events),
A, B, C, or D. The command also disables these cleared triggers. Use the Set Trigger
(ST) command, or the bus analyzer configuration dialog box, to set trigger values.
windows. Triggers are enabled by Use the Trigger Enable (TE) and Trigger Disable
(TD) commands to enable and disable triggers.
Example:
CTAB
Clears triggers A and B.
Example:
Freescale Semiconductor, Inc.
For More Information: www.freescale.com