Microcontrollers Data Sheet

Serial Peripheral Interface Module (SPI)
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
212 Freescale Semiconductor
SPE — SPI Enable Bit
This read/write bit enables the SPI module. Clearing SPE causes a partial reset of the SPI. See 15.8
Resetting the SPI. Reset clears the SPE bit.
1 = SPI module enabled
0 = SPI module disabled
SPTIE— SPI Transmit Interrupt Enable Bit
This read/write bit enables CPU interrupt requests generated by the SPTE bit. SPTE is set when a byte
transfers from the transmit data register to the shift register. Reset clears the SPTIE bit.
1 = SPTE CPU interrupt requests enabled
0 = SPTE CPU interrupt requests disabled
15.12.2 SPI Status and Control Register
The SPI status and control register (SPSCR) contains flags to signal these conditions:
Receive data register full
Failure to clear SPRF bit before next byte is received (overflow error)
Inconsistent logic level on SS
pin (mode fault error)
Transmit data register empty
The SPI status and control register also contains bits that perform these functions:
Enable error interrupts
Enable mode fault error detection
Select master SPI baud rate
SPRF — SPI Receiver Full Bit
This clearable, read-only flag is set each time a byte transfers from the shift register to the receive data
register. SPRF generates a CPU interrupt request if the SPRIE bit in the SPI control register is set also.
During an SPRF CPU interrupt (DMAS = 0), the CPU clears SPRF by reading the SPI status and
control register with SPRF set and then reading the SPI data register.
Reset clears the SPRF bit.
1 = Receive data register full
0 = Receive data register not full
ERRIE — Error Interrupt Enable Bit
This read/write bit enables the MODF and OVRF bits to generate CPU interrupt requests. Reset clears
the ERRIE bit.
1 = MODF and OVRF can generate CPU interrupt requests.
0 = MODF and OVRF cannot generate CPU interrupt requests.
Address: $0045
Bit 7654321Bit 0
Read: SPRF
ERRIE
OVRF MODF SPTE
MODFEN SPR1 SPR0
Write:R RRR
Reset:00001000
R=Reserved
Figure 15-15. SPI Status and Control Register (SPSCR)