Instruction Manual

34
35
You may need the following to change your baeries:
1. Metric/standard socket set and ratchet.
2. Adjustable wrench.
To replace the baeries:
1. Turn o the power to the controller.
2. Make sure that the power chair is in drive mode.
3. Remove the seat. See“ DISASSEMBLY AND ASSEMBLY ”.
4. Loosen the screws and remove the body shroud. See“ DISASSEMBLY AND ASSEMBLY ”.
5. Disconnect the baery cables from the baery terminals of each baery. (See gure 10).
6. Li the front and rear baeries out of the power base.
7. Install new baeries into the power base. Make sure the terminals of each baery are facing the
front of the power chair. (See gure 30).
8. Connect the both baery cable. Make sure that the baery terminal hardware is facing the
correct direcon. (See gure 30).
9. Reinstall the body shroud and ghten the screws to secure the shroud.
10. Reinstall the seat.
11. Charge the baeries. See“ BATTERIES AND CHARGING ”.
WARNING!
The baery cables must be disconnected from the baery terminals before sliding
the baery tray back or cable damage could result.
WARNING!
Make sure you ghten the fasteners so that the connecons are secure.
CORRECTIVE MAINTENANCE
If the baery condion meter does not light up when you turn on the power:
1. Check the harness connecons. Make sure they are ght.
2. Check the circuit breaker. Reset it if necessary.
3. Check the baery connecons.
If the above condions prove normal, you can load test the baeries with a baery load tester. These
testers are available at automotive parts stores. Disconnect both batteries before load testing and
follow the direcons that come with the load tester. If either one of the baeries fails the load test,
replace both of them. If your power chair sll does not power up, contact your Authorized Freerider
Agent.
APPENDIX-SPECI F I C A T I ONS
Figure 30.Baeries replaces.
FR-168W SPECIFICATIONS
Weight capacity 159Kgs / 350 lbs
Total Weight 106Kgs / 233.5lbs
Standard seat weight 25Kgs / 55lbs
Max. seat dimensions 20"x21"
Maximum speed Up to 6.4Km / 4mph
Ground clearance 9.2cm / 3.62" (See gure 31.)
Turning radius 53.2cm / 21" (See gure 31.)
Overall length 114.7cm / 45.16" (See gure 31.)
Overall width 67.54cm / 26.59" (See gure 31.)
Wheels Drive Wheel :12.5"
Front casters 6" solid
Rear casters 6" solid
Suspension Front & Rear caster
Drive train Two-motor, mid-wheel drive
Braking system Intelligent braking(electronic, regenerave disc brakes)
Standard electronics 60amp,Dynamic shark controller
Specialty controls N/A
Baery charger O-board,5 amp
Per-charge range Up to 12.27miles/19.75km (160kg/350lbs)
Baery requirements 12volt ,deep cycle
Baery size 50Ah
Baery weight 14Kgs / 31lbs each
Standard colors Blue / Burgundy Red