User guide

32
SE T-UP MENU DESCRIPTION SET TINGS
A cceleration 3
Deceleration 8
F o r war d Speed 10
R everse Speed 5
R educe Speed 4
Buzzer V olume 10
Motor R esistance 60
Sleep Time 15
Maximum Cur rent 70
P a rk Brak e Delay 4
OPTION MENU DESCRIPTION SET TINGS
Single-Ended P o t
OFF
Standar d Speed P o t OFF
Motor R everse OFF
P ot R everse OFF
Brak e Checking ON
Load Compensation ON
Enable Sleep ON
Check for Slope OFF
Cur rent Limit T i mer ON
ST A TUS F A UL T CODES
FL AS H C ODE F A UL T DISPL A YED
(No. of flashes) B Y PROGR AMMER
FREERIDER SCOOTER
CONDITION
COMMENT
1 Flash Driving still possible
The batter y voltage has dropped below 23 3 volts in neutr al
R
echarge th e batteries
soon
2 Flashes Driv e inhibited
The batter y voltage at Controller has dropped to 16 5 volts
Check the batter y condition and the connections 
3 Flashes Driv e inhibited The batter y voltage at the controller is greater the 32
volts
Check the batter y condition and the connections  Suspect a
charger malfunction 
4 Flashes Driv e inhibited The Controller has dete cted a shorted or over work ed motor

Check the loom for shorts or check out th e motor

Contact you
r
Ser vice Agent
5 Flashes Driv e inhibited Check the F reewheel Lever is fully
engaged
Check t he
P
ark Brak e
and wiring for open or short cir
cuits
Contact your Ser vice Agent
6 Flashes
Driv e inhibited  Driv e possible if neutral
selected within 10 secs 
R e turn th e speed lever to neutral R e -adjust th e speed lever
neutral if necessar y

Consult your Ser vice Agent
7 Flashes Driv e inhibited Check speed pot wiring for open or short cir
cuits
Speed pot
may not be cor rectly set
up 
Contact your Ser vice Agent
8 Flashes Driv e inhibited
Motor or wiring is faulty  Contact your Ser vice Agent
Battery needs recharging
Battery voltage
too low
Battery voltage too high
Cur rent limit time out
Brak e fault
Out of neutral when power
switched on at k e y switch
Speed pot er ror
(wig wag]
Motor volts er ror
Other internal er rors
Driv e inhibited
Contact your Ser vice Agent
9 Flashes
SPEED CONTROLLER SET TINGS
The for ward-rev e rse speed Control ler (Fig 37 page 30] is a
state- of-the - art microprocessor designed to give smooth and
safe operation  F or m a ximum performance, protection and
convenience
the Controller is housed in a solid die cast
aluminium case situated under the rear body cover 
The speed Controller , ‘Dynamic’ mode l DS72K O1(Rhino] is
programmed by F r eerider to obtain the m a ximum performance
and safety for your Scooter

Warning: P e rformance adjustments should not be made wh ich
could put the operator in a serious situation of cont rol or
braking P erformance adjustments should only be made by a
person fu lly trained and conv ersant with the programming
process and it’s capabilities 
Warning: Incor rect setti ngs could cause injur y to the Scooter
operator and/or to bystander s, or damage to the vehicle
and/or sur rounding propert y  If in doubt consult your
F reerider Manufacturer
The original manufacturer ’ s settings for this Scooter are: