User guide

31
LIGHTING FUSE
A fuse protects your Richmond lighting from receiving an
overload of electrical cur rent The fuse used in the Richmond
is the same type wh ich is found on automobiles  In the
unlik ely event that the fuse should ‘blow ’ and needs rep lacing
(Fig
38] use only a fuse of a 10amp rating  Please note this
size of fuse has been se lected to give your Scooter the best
protection without premature blowing 
FIG 40
FIG 38
Warning : Do not use fuses with a higher rating than 10amps
as this may cause permanent f ailure to the wiring and wiring
connectors
or personal injur y

FIG 39
The 10amp fuse is located under the Scooter’s black
rubber handle bar cover at the base of your handle bars
(Fig
39]  The fuse is positioned in a blackplastic
housing wh ich is sealed by a hinged lid 
F o r access to the fuse, lift the black rubber handle bar cover ,
lift
the fus e block on it’s wire, lift up the fuse lid and
withdraw the ‘blown ’ fuse (fig 39] R eplace the blown fuse
with recommended 10amp (red] fuse, close fuse lid and
replace fuse
block  Lowe r the black handle bar cover onto the
front body cover

REA R LIGHT WIRING CONNECTOR
The rear lights mounted to your Richmond body cover
are connected to the main wiring loom by a white plug
and sock et (F ig 40). T o remove the rear body cover first
remove your seat. The cover is positioned onto the
Scooter by ‘ velcr o
®
’ type fittings. Simply lift up the
cover , making certain you are clear of the seat mounting
post. Before fully lifting the body cover unlatch the
lighting plug and sock et by pushing down on the locking
latch., the body cover can now be carefully removed.