Installation & Assembly

24"
24"
6"
Concrete Pad
DETAIL B
SCALE 1 : 3
8
9
3/8" Drill Diameter
to a Depth of 4"
Step 1: Determine installation location. Verify concrete footing is a minimum of 24" long x 24" wide x 6" thick. If the concrete pad is at
an angle, steel washers are required to act as shims (Shims not provided). If there is not already an existing pad, approximately (3)
80lb. bags will be needed. Allow concrete to cure per concrete manufacturers guidelines. ( If a In-Ground appearance is desired
recess the concrete pad 4" below finished grade )
Step 2: With two people place the Instrument Assembly onto the concrete pad and mark the center of the holes on the surface
mount plate. After you have made your marks, set aside the Instrument in order to drill for anchor holes. With a hammer or rotary
drill, drill through concrete at marked locations. Drill to a minimum depth of 4". A 3/8" masonry drill bit will be needed.
Step 3: Place the Instrument back over the drilled out holes. Insert provided anchor bolts into aligned holes. Position anchor nut so
that it is flush with the top of the bolt. Pound anchor bolts into the hole until the anchor washer is flush with the steel base. Tighten
anchor bolts until they are snug. Cover remaining bolt sections with provided nut caps.
Step 4: Verify the correct placement, levelness, and finished height of the instrument. Also check for sufficient clearance around the
instrument. A 36" perimeter around the instrument is recommended for wheelchair accessibility.
Step 5: If installing onto wet concrete, us the wet set anchor manufacturers guidelines
for installation procedures.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF FREENOTES HARMONY
PARK IS PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
WWW.FREENOTESHARMONYPARK.COM
SHEET 3 OF 3
TITLE:
SCALE: 1:14
REVISION: A
DATE: 11/21/2018
DWG. NO.
In Ground and Surface Mount Installation
TREE-INSTALL