Installation & Assembly

48"
30"
6"
1
Concrete Pad
5
DETAIL C
SCALE 1 : 6
9
3/8" Drill Diameter
to a Depth of 4"
10
Step 1: Standard height for Surface Mount Posts are 60". The height of Surface Mount Steel Posts can not be adjusted.
Step 2: Determine installation location. Verify concrete footing is a minimum of 48" long x 30" wide x 6" thick. If the concrete pad is at
an angle, steel washers are required to act as shims (Shims not provided). If there is not already an existing pad, approximately
(9) 80lb. bags will be needed. Allow concrete to cure per concrete manufacturers guidelines.
Step 3: With two people place the Instrument Assembly with Posts attached onto the concrete pad and mark the center of the holes
on the surface mount bases. After you have made your marks, set aside the Instrument in order to drill for anchor holes. With a
hammer or rotary drill, drill through concrete at marked locations. Drill to a minimum depth of 4". A 3/8" masonry drill bit will be
needed.
Step 4: Place the Instrument back over the drilled out holes. Insert provided anchor bolts into aligned holes. Position anchor nut so that
it is flush with the top of the bolt. Pound anchor bolts into the hole until the anchor washer is flush with the surface mount bases.
Tighten anchor bolts until they are snug. Cover remaining bolt sections with provided nut caps.
Step 5: Verify the correct placement, levelness, and finished height of the Instrument.
Check for sufficient clearance around the Instrument, a 36" perimeter
around the Instrument is recommended for wheelchair accessibility.
Step 6: If installing onto wet concrete, us the wet set anchor manufacturers
guidelines for installation procedures.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF FREENOTES HARMONY
PARK IS PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
WWW.FREENOTESHARMONYPARK.COM
SHEET 4 OF 4
TITLE:
SCALE: 1:16
REVISION: B
DATE: 2/9/2018
DWG. NO.
Surface Mount Installation
SWRL-INSTALL