Installation & Assembly

3
4
"
36" 24"
7
1
2
"
6"
Concrete Pad
1
2
DETAIL A
SCALE 1 : 4
3/8" Drill Diameter
to a Depth of 4"
3
4
Step 1: Determine installation location. Verify concrete footing is a Parts List:
minimum of 36" long x 24" wide x 6" thick. If the concrete pad
is at an angle, steel washers are required to act as shims
(Shims not provided). If there is not already an existing pad,
approximately (5) 80lb. bags will be needed. Allow concrete
to cure per concrete manufacturers guidelines.
( If a In-Ground appearance is desired recess the concrete
pad 4" below finished grade )
Step 2: With two people place the Uprights individually onto the
concrete pad and mark the center of the holes on the surface
mount plates. Use the diagram below as a guide for Upright
placements. After you have made your marks, set aside the Uprights in order to drill for anchor holes. With a hammer or rotary
drill, drill through concrete at marked locations. Drill to a minimum depth of 4". A 3/8" masonry drill bit will be needed.
Step 3: Place the Uprights back over the drilled out holes. Insert provided anchor bolts into aligned holes. Position anchor nut so that it
is flush with the top of the bolt. Pound anchor bolts into the hole until the anchor washer is flush with the Upright Bases. Tighten
anchor bolts until they are snug. Cover remaining bolt sections with provided nut caps.
Step 4: Verify the correct placement, levelness, and finished height
of the instrument. Also check for sufficient clearance around
the instrument. A 36" perimeter around the instrument is
recommended for wheelchair accessibility.
Step 5: If installing onto wet concrete, us the wet set anchor
manufacturers guidelines for installation procedures.
ITEM NO. PART DESCRIPTION QTY.
1 Steel Outer Upright 2
2 Steel Inner Upright 1
3 3/8"-16 Wedge Expansion Anchor, 3.75"lg. SS 11
4 35/64" Hex Nut Cap 11
5 Manta Ray Chime Assembly 1
6 3/8"-16 Button Head Screw, 5"lg. SS, Hex Drive 4
7 3/8"-16 Tri-Groove Nut, Zn 5
8 ø13/32" ID x ø7/8" OD, Washer SS 8
9 ø.385" ID x ø3/4" OD Spacer, 1.5"lg. LDPE 4
10 Blue Locktite 1
11 #30 Square-Drive Socket 1
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF FREENOTES HARMONY
PARK IS PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
WWW.FREENOTESHARMONYPARK.COM
SHEET 2 OF 3
TITLE:
SCALE: 1:16
REVISION: A
DATE: 2/7/2018
DWG. NO.
In Ground and Surface Mount Installation with Parts List
MRAY-INSTALL