Use and Care Manual

OPERATION
INFLATING / DEFLATING
1.
2.
3.
4.
5.
Connect the tool to the air source.
Remove the tire’s dust cap.
Depress the air chuck clip. Then press onto the tire
valve stem firmly and release the chuck clip once
the chuck is attached. Ensure there is no air
leaking.
Press the trigger untill resistance is felt to deflate
the tire. Press the trigger down fully to inflate the
tire.
Once the pressure gauge reaches the desired
pressure remove the air chuck from the tire valve.
InflateDeflate
USER NOTES
1.
2.
The inflator needs an air source to inflate. It
CANNOT inflate by itself.
The LED gauge is powered by 2 AAA batteries
(included).
To install or replace batteries first peel back the
rubber cover.
Then open the cap and insert batteries.
The inflator will automatically power on in 1.5
seconds when connected to the tire, otherwise,
press ON/LIGHT button to power the tool on.
When the inflator is on, simply press ON/LIGHT
button to turn on the backlight. The backlight will
automatically diminish in 15 seconds.
3.
4.
To change the pressure unit press the UNIT button
while the infator is on and choose the desired unit.
The chosen unit will be set as default for the
following usage.
5.
ON/LIGHT
UNIT
MODEL: FS1DTI
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-567208
MODEL: FS1DTI
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
MAINTENANCE
Disconnect the tool from the air source
before performing any maintenance on
the tool.
WARNING:
CLEANING
Clean the entire tool with a cotton rag after each use.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and maybe damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
09