Installation Instructions

ADS-B FDL-DB Dual Band Series

Installation Manual

Document No. 88552 Rev A

5-42

• ADS-B Pass Thru

* Only used in conjunction with FTM-190C, external Transponder Monitor.

**When the Port 6 Output is set to Other 3, the corresponding Port 6 Input must be

configured for TMAP, as well. The baud rate must be set to 38400 to ensure proper

communication with the device.

Refer to Section 5.1.1.2 for details on selecting serial output settings.

The display screen is as shown below with one of the options from the list above.

Rotate the CODE knob either clockwise or counterclockwise to display the options above and

select the correct serial output type. Once selected, press the ENT button to confirm your

selection and move to the next configuration item in the setup mode.

If “Not Used” is selected then the serial output line speed configuration mode is not

displayed and the next configuration mode item is displayed.

5.3.2.10 Serial OUT Channel X Line Speed

(X = channel number) The following options are offered for selecting the serial output baud rate

for each channel data type:

• 4800

• 9600

• 19200

• 38400

• 57600

• 115200

• 230400

The display screen is as shown below with one of the options from the list above.

Rotate the CODE knob either clockwise or counterclockwise to display the options mentioned

above and select the correct serial output speed. Once selected, press the ENT button to

confirm your selection and move to the next configuration item in the setup mode.