Installation Instructions

ADS-B FDL-DB Dual Band Series
Installation Manual
Document No. 88552 Rev A
FFS Copyright © 2020 All rights reserved.
5-35
Figure 31: FDL-DB set displayout command
“trafficOnly” will provide traffic information to the display (position, ground track,
etc.) but no weather or other flight information.
“fisbOnly” will provide weather and flight information (NOTAMS, TFRs, ATIS, etc.)
but no traffic.
“traffic&fisb” will provide traffic, weather, and flight information simultaneously.
“repinfo” will provide identification information on whether the traffic target received
is on the 1090ES (“e”) frequency band or the UAT (“u”) band.
“ssi on/off” will turn on or off the received radio signal frequency strength by the
FDL-DB dual band systems.
5.3 Configuration and Setup Using TC978
Do not use Configuration Mode during flight.
The system should be configured during initial system installation by a qualified technician. The
configuration items list in Section Error! Reference source not found. should be used to
document the system installation for future reference. To view or change these settings you
must enter TC978 Configuration Mode.
The configuration setup screen is the first thing displayed on startup when a completely new
FDL-DB-XVR system is installed and powered up for the first time. After a configuration has
been programmed, the system will power up in normal operating mode and the configuration will
be stored in the FDL-DB-XVR.
Anytime “Configuration Mode” is entered using the TC978, the user must re-
enter ALL configuration items, including serial and ARINC port settings.
5.3.1 Entering Configuration Mode
To enter TC978 configuration mode:
• Hold down the FN button while turning the Mode Selection knob from OFF to any
operating mode.