Installation Guide

8
Base Plate Assembly For Corner Post When Surface Mounting
a.) Attach plate to the bottom of the corner post.
b.) Align counter-sunk plate holes with post boss.
c.) Insert the four (4) 2
1
⁄
1
⁄
1
2
⁄2⁄
" screws provided in the post kit into the screw boss using a Phillips bit and a drill.
DO NOT attempt to install by hand.
Fig. B
Fig. A
Top of Post
Bottom of Post
Fig. C
Holes not used
Fig. 1
3
⁄
3
⁄
3
8
⁄8⁄
" Hardware
Post
Concrete
3
⁄
3
⁄
3
8
⁄8⁄
" Holes
Determine the desired location for each post.
Use the post assembly to mark the holes for
the concrete anchors, as required by applicable
building codes. The holes in the surface
mounting plate will allow for a max size of a
3
⁄
3
⁄
3
8
⁄8⁄
"
anchor (Fig. 1).
Mark and pre-drill holes based on local building
codes (Fig. 1).
2
a
.
Measure center-to-center distance of posts and
install accordingly. Proceed systematically with
post, panel, post, etc.
Surface Mount Post Installation Option - Concrete Surface: