Installation Guide

11
7.
8.
9.
a.
For Vertical Style:
Install vertical in ll boards as shown. Boards
should  t inside adaptor strip (Fig. 9a).
Once all in ll boards are installed, insert top rail
and attach the top rail with two
3
⁄
3
⁄
3
4"
⁄4"⁄
Hex Head
screws on each side of post (in small groove).
Remove the 2" spacer blocks (Fig. 10).
b.
For Horizontal Style:
Install horizontal in ll boards as shown. Boards
should  t inside adaptor strip (Fig. 9b).
Fig. 9a
Fig. 9b
10.
Snap/slide post cover (from post kit) into place
by holding cover approximately 6" from top of
post. Hook one side of the cover and push down
to snap the other side. Slide the cover down the
post to hide the screws. (Fig. 11)
Install post cap to top of post. Use a soft rubber
mallet if necessary to obtain a  rm  t. (Fig. 11)
Fig. 11
End Cap
Line Cap
Corner Cap
Cover
Strip
Cover
Strip
Line Cover
Fig. 10