User Guide

ValueLoader Administration
Configuring the ValueLoader
36 ValueLoader LTO Tape Autoloader User Manual
To access the Configuration menu from the Home Screen or main
menu, press the
[+] or [-] button until “Configuration” appears on
the top line of the LCD screen. Press the
[Enter] button and then [+]
or
[-] to access the available options. Press the [Enter] button to
execute the displayed menu option.
Resetting the
ValueLoader
3
This option resets the ValueLoader robotics and the tape drive
within the ValueLoader, forces a new cartridge inventory, and
clears any current error condition.
To access this option, follow these steps:
1 From the Home Screen or main menu, press the [+] or [-] button
until “Configuration” appears on the top line of the LCD
screen.
2 Press the [Enter] button to select.
3 Press the [+] or [-] button until “Reset” appears on the LCD
screen.
4 Press [Enter] to reset the ValueLoader.
After initialization, the ValueLoader returns to normal operation
and displays the Home screen.
Changing the SCSI
ID
3
This option changes the SCSI IDs that the ValueLoader uses. The
ValueLoader operates as a dual SCSI device with two separate
SCSI IDs: one for the tape drive and the other for the ValueLoader
robotics.
The default SCSI IDs for the ValueLoader are 6 for the tape drive
and 5 for the robotics. You should only need to change the SCSI
IDs if there are other devices on the SCSI bus with the same SCSI
IDs.
Note: This option is primarily used if the ValueLoader is in an
error state.