User Guide

Installing the ValueLoader
Connecting the SCSI and Power Cables
ValueLoader LTO Tape Autoloader User Manual 13
4 Slide the ValueLoader onto the rails and secure the mounting
bracket to the rack using the screws and clip nuts from the
rackmount hardware package, as shown in figure 7
.
Figure 7 Sliding the
ValueLoader into the
Rack Slot
Connecting the SCSI and Power Cables 1
To connect the SCSI and power cables to the ValueLoader, follow
these steps:
1 Shut down and turn off the selected server. Turn off all
attached accessory devices, such as printers and other SCSI
devices. Remove the power cables from the server and all
attached accessories.
Caution: Failure to remove the power cables from these
devices may result in damage to the
ValueLoader.