User Guide

Installing the ValueLoader
Installing the ValueLoader into a Rack
ValueLoader LTO Tape Autoloader User Manual 11
Installing the ValueLoader into a Rack 1
The ValueLoader fits all standard 19-inch racks, taking up 2U of
space. To install the ValueLoader into a rack, you need to install
the mounting brackets on both sides of the ValueLoader and the
rails in the selected rack location.
To install the ValueLoader, follow these steps:
1 Use a screwdriver or Torx T10 to remove the two screws near
the front on each side of the ValueLoader.
2 Using the screws you removed in step 1, secure one mounting
bracket from the rack kit to each side of the ValueLoader, as
shown in figure 5
.
Figure 5 Installing
Mounting Brackets
(Left Side Shown)