User Manual

! !! !!!!!!!!!!!!!!!!!!!!!!!!! !
!
!
9!
TABLE!OF!CONTENTS!
Chapter One: Product Overview ______________________________________________________ 11!
1.1 INtroduction ________________________________________________________________________________ 11!
1.1.1 Router Mode ______________________________________________________________________________ 11!
1.1.2 Bridge Mode ______________________________________________________________________________ 11!
1.2 Product OVERVIEW: WiMAX Transmission Features ______________________________________________ 12!
1.2.1 Dynamic Adaptation ________________________________________________________________________ 12!
1.2.2 Adaptive Coding ___________________________________________________________________________ 12!
1.2.3 Adaptive Modulation _______________________________________________________________________ 12!
1.2.4 Traffic Classification _______________________________________________________________________ 12!
1.3 System Tour ________________________________________________________________________________ 13!
1.3.1 Main Features _____________________________________________________________________________ 13!
1.3.2 Package Contents Checklist __________________________________________________________________ 14!
Chapter Two: Basic Installation ______________________________________________________ 15!
2.1 Safety Measures _____________________________________________________________________________ 15!
2.2 System Requirements ________________________________________________________________________ 15!
2.3.1 Point to Point (PTP) ________________________________________________________________________ 16!
Point to Point deployment uses frequencies in the 5 GHz range and requires that the transmission medium is line of
sight and tightly beamed from transmitter to receiver. The diagram shows a typical PTP scenario. _______________ 16!
2.3.2 Point to Multipoint (PTM) ___________________________________________________________________ 17!
2.4 Hardware Installation _________________________________________________________________________ 18!
2.4.1 Choosing a Location ________________________________________________________________________ 18!
2.4.2 POLE installation steps ______________________________________________________________________ 19!
2.4.3 Wall installation steps _______________________________________________________________________ 22!
2.4.4 installation Check up _______________________________________________________________________ 23!
Chapter Three: Web Configuration ___________________________________________________ 24!
3.1 Logging In _________________________________________________________________________________ 25!
3.2 System Settings _____________________________________________________________________________ 27!
3.2.1 Changing system Configuration _______________________________________________________________ 27!
3.2.2 Upgrade system firmware ____________________________________________________________________ 27!
3.2.3 CPE Configuration Parameters ________________________________________________________________ 30!
3.2.4 IP address assignment and Configuration file retrieval _____________________________________________ 34!
3.2.5 Changing configuration file after initialization ___________________________________________________ 35!
3.2.6 SNMP Configuration Tool ___________________________________________________________________ 35!
3.2.7 Factory Reset procedure _____________________________________________________________________ 35!
3.2.8 Status LED _______________________________________________________________________________ 35!
3.2.9 Authentication support ______________________________________________________________________ 36!
Chapter Four: Cli Commands ________________________________________________________ 37!
4.1 loadImage _________________________________________________________________________________ 37!
4.2 upgradeSw _________________________________________________________________________________ 38!
4.3 showVersions _______________________________________________________________________________ 38!
4.4 showSysConfiguration ________________________________________________________________________ 39!
4.5 setSysConfiguration __________________________________________________________________________ 39!
4.6 saveSysConfiguration ________________________________________________________________________ 41!
4.7 downloadConfigFile _________________________________________________________________________ 41!
4.8 uploadConfigFile ____________________________________________________________________________ 42!
4.9 addToScanList ______________________________________________________________________________ 42!
4.10 removeFromScanList ________________________________________________________________________ 43!
4.11 addToPreferredNspList ______________________________________________________________________ 43!
4.12 removeFromPreferredNspList _________________________________________________________________ 44!
4.13 updateAccount _____________________________________________________________________________ 44!
4.14 getMIB ___________________________________________________________________________________ 45!