User Manual

! !! !!!!!!!!!!!!!!!!!!!!!!!!! !

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC and to EN 301 489-1 rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Operation is subject to the following two conditions:

1 This device may not cause harmful interference.

2 This device must accept any interference received, including interference that may cause

undesired operation.

Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to part 15 of the FCC rules and to EN 301 489-1 rules. These limits are

designed to provide reasonable protection against harmful interference when the equipment is

operated in a residential environment notwithstanding use in commercial, business and

industrial environments. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications.

FCC Radiation Hazard Warning

To comply with FCC and ETSI RF exposure requirement, this equipment must be installed

and operated in accordance with provided instructions and the antenna(s) used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all

persons and must not be co-located or operating in conjunction with any other antenna or

transmitter. End-users and installers must be provided with antenna installation instructions

and transmitter operating conditions for satisfying RF exposure compliance.