User Manual

! !! !!!!!!!!!!!!!!!!!!!!!!!!! !
!
!
23!
2.4.4!INSTALLATION!CHECK!UP!
The CPE is equipped with a green LED that indicates the status of the CPE software. The LED
flashes with different speeds thus indicating three modes:
1. Before firmware loading "!Off!
2. During!Firmware!loading!"!!Rapid!flashing!
3. Scanning!for!BS!"!Slow!flashing!
4. Connected!to!a!BS!" On!
!
For!correct!installation,!you!need!to!do!the!following:!!!
!
I. Ensure the CPE is directed towards the WiMAX Base Station specified in the Work
Order.
II. Access the CPE webpage by entering the default IP address http://192.168.0.25 in the
browser address field. Click on the RF-STAT button to continuously read the RSSI level
from the CPE.
III. Adjust the direction of the CPE in small increments (both horizontally and vertically)
until the best RSSI level is achieved.
IV. Tighten all mounting hardware screws and clamps. Record the best achieved RSSI value
on the Work Order.
!
!
!
!
!
!
!
!