User Manual

! !! !!!!!!!!!!!!!!!!!!!!!!!!! !
!
!
53!
4.23!CONFIGUREPPPOE!
!
ConfigurePPPoE
Arguments
mode (M)
This parameter indicates whether PPP over
Ethernet will be configured in client mode or
proxy mode.
Client: configure PPPoE client
proxy: configure PPPoE proxy
maxSessionsCount (O)
Maximum total number of PPPoE sessions
allowed before incoming PPPoE packets are
ignored. (The default is 16).
authenticationMode (O)
The authentication mode to configure PPPoE
to use. It could be:
pap: enable using pap protocol
chap: enable using chap protocol
noAuth: no authentication needed
userName (O)
The user name to use to authenticate the
peer.
Password (O)
The password to use to authenticate the peer
Description
Configure PPPoE (client or proxy) on the CPE. This command not
making an action for now but it is saving the configuration of PPPoE
client in the configurations and proxy is not yet supported.
Examples
configurePPPoE client 16 pap frcuser frc2009
configurePPPoE client authenticationMode=chap username=frcuser
password=frc2009
!
!
!
!
!
!
!
!