User Manual

! !! !!!!!!!!!!!!!!!!!!!!!!!!! !
!
!
35!
3.2.5!CHANGING!CONFIGURATION!FILE!AFTER!INITIALIZATION!
!
To trigger the CPE to use a different configuration file other than the one retrieved in its initialization;
the downloadConfigFile command must be used.
Please refer to downloadConfigFile command for more information about changing the
configuration file after initialization.
!
3.2.6!SNMP!CONFIGURATION!TOOL!
!
MG-SOFT MIB Browser is one of the SNMP Browser tools. Also MG-soft is a flexible, technically
superb, powerful and user-friendly SNMP Browser. MIB Browser allows you to perform SNMP Get,
SNMP GetNext, SNMP GetBulk and SNMP Set operations. To obtain MG-SOFT MIB Browser
software you can refer to http://www.mg-soft.com/download.html.
3.2.7!FACTORY!RESET!PROCEDURE!
!
The factory reset procedure is used to restore the system configurations to their defaults. For this
purpose a configuration file containing the default factory settings should be maintained on flash.
The factory reset can be triggered by either pushing a HW push button or from the CLI/Web
interfaces.
To handle wrongful presses on the push button, it must be pressed for at least 5 seconds.
3.2.8!STATUS!LED!
!
The CPE is equipped with a green LED that indicates the status of the CPE software. The LED
flashes with different speeds thus indicating three modes:
1. Before firmware loading -> Off
1. During Firmware loading -> Rapid flashing
2. Scanning for BS -> Slow flashing
3. Connected to a BS (Operational) -> On
!
!
!
!
!
!