User's Manual

  


FRCGroupProprietaryandConfidential
FRCWimaxoutdoorCPE–UserManualrev4.0
 ‐36‐

3.4.1.2IPMODE

By default, the CPE’s WAN interface IP mode is automatically configured with IP settings from
a Dynamic Host Configuration Protocol (DHCP) server. Alternatively, you can set a static IP
address for the WAN interface.
To set WAN interface in static IP mode, perform the following steps:
1. Enter into the Network Tab field.
2. Select WAN field.
3. Select Static.
4. Specify the required IP Address, subnetMask and Gateway settings.
 IP Address: Specifies an IP address for wireless interface of the CPE. Valid IP
addresses consist of four decimal numbers, 0 to 255, separated by periods. (Default:
172.25.25.30.)
 Subnet Mask: Indicates the local subnet mask. (Default: 255.255.255.0)
 Gateway: The default gateway is the IP address of the router for the CPE, which is
used if the requested destination address is not on the local subnet. (Default:
172.25.25.1)
5. Click Apply.

3.4.2NAT

To enable or disable the NAT setting, perform the following steps:
1. Enter into the Network Tab field.
2. Select NAT field.
3. Select Enable or Disable.
4. Click Apply.
Click Save to preserve the NAT setting after rebooting the CPE.


