User's Manual

  


FRCGroupProprietaryandConfidential
FRCWimaxoutdoorCPE–UserManualrev4.0
 ‐35‐

3.4NETWORKSETTING

3.4.1WAN

3.4.1.1NETWORKMODE

To set network mode to be bridge mode, router mode or router mode without DHCP
server, perform the following steps:
1. Enter into the Network Tab field.
2. Select WAN field.
3. Specify the required network mode as shown in Figure 18.
4. Click Apply.
Click Save to preserve the network mode after rebooting the CPE.


Figure 18: WAN settings.


The available network modules are:
 Bridge Mode: if enabled, CPE act as transparent layer two bridge.
 Router Mode: if enabled, CPE act as layer three router with enabled DHCP server for LAN.
 Router Mode(NO-DHCP): if enabled, CPE act as layer three router without DHCP server for
LAN.
When DHCP Server enabled, CPE automatically assigns IP addresses to computers connected to
Ethernet port.

