User's Manual

  


FRCGroupProprietaryandConfidential
FRCWimaxoutdoorCPE–UserManualrev4.0
 ‐22‐

Forcorrectinstallation, please check the following:
1. Ensure the CPE is directed towards the WiMAX Base Station.
2. Adjust the direction of the CPE in small increments (both horizontally and vertically) while
checking signal strength LEDs until the best RSSI level is achieved.
3. Optionally you can monitor live RF statistics by clicking RF-Stat through web interface. Please
refer to "Web Graphic User Interface" section for more details.
4. Tighten all mounting hardware screws and clamps.

2.3.5CPESIGNALSTRENGTH

The CPE is equipped with LEDs of four different colors to indicate the RSSI of the WIMAX
CPE as shown in Figure 6. The LEDs indicate the signal strength as follow:
 Very Weak Signal  Red Light
 Weak Signal  Orange Light
 Good Signal  Blue Light
 Excellent Signal  Green Light
Figure 6: CPE LEDs and factory reset button.
Red LED also acts as Status LED with the following modes:
 During Firmware loading  Rapid flashing.
 Scanning for BS  Slow flashing.
 Connected to a BS  On.
2.3.6FACTORYRESETPROCEDURE