Use and Care Manual

1. Installation:
• Remove all contents from the box.
• Arrange the 4 base supports onto the base. Connect the transformer plug with the base socket.
• Unfold the umbrella-shaped snow container.
• Take the Christmas tree and insert the lower part into the support of the umbrella-shaped snow container.
Turn the tree pipe so that both holes are fully aligned, then fasten it with a screw.
• Fit the uppper tree pipe with the lower pipe. Note: This should be tightly tted to avoid any air leakage. If
there is a gap, the snow will spray through it.
• Fit the tree topper on the pipe. Note: The top is designed to return the snowakes and must be set square in
the center to avoid snowakes ying everywhere.
• Unfold the tree branches horizontally and arrange them to the desired shape.
• Decorate the Christmas tree with the lamp string and insert the plug into the number 2 socket on the base.
Coil the light string around the tree branches.
• Arrange and secure the ornaments on the tree branches so they don’t fall into the umbrella and block the
ow of the snowakes.
2. Functionality test:
• All of the above instructions must be completed.
• Clean o all foreign matter in the umbrella-shaped container to avoid blocking the ow of snowakes.
• Set the switch to OFF and connect the transformer with the power source.
• Place a small amount of snowakes at the bottom of the snow container, and turn on the switch to see if
akes spout out from the top of the tree. Check that the music and lights function properly. If there are any
issues, check the wiring again.
3. Pour in the akes:
• Turn o the switch.
• Pour the snowakes into the umbrella-shaped base and distribute evenly. Set some aside for later use.
4. Completion of assembly:
• Turn on the switch. You will see snowakes spouting from the top of the tree, sparkly lights, and hear the
music starting. All assembling is now completed.
5. Adjust and enjoy:
• Adjust the wind switch to get the appropriate airow for the best snow-ying eect and avoid akes ying
out of the container.
• Snow speed can be adjusted at the bottom of the base by the power button.
Music is controlled by the switch and can be turned o when not needed.
I —Music turned o, and other functions are normal
II—Music turned on, and all functions are normal
Lights are controlled by pressing the button to the 3 dierent settings described below.
I —Steady
II—Twinkle
III—O
ASSEMBLY INSTRUCTIONS