Use and Care Guide
3
holder is fragile, and should be handled with care. c. When
there is only one lantern at two ends of lamp support, the
lamp post may fall due to being imbalanced; therefore, you
should stabilize the lamp post before installation of the
second lamp holder. At this time, it will be better to ask
another person to assist the installation.
Repeat the above mentioned C/D step to complete the
installation of the second lamp holder.
E. Install the two lamp pendants (18) for decoration on the
lower part of lamp holder.
4. Positioning, power-on, waterproof and
examination
A. Positioning: Place the street lamp modules at the
position arranged. Note: a. If the street lamp will be
outdoors, please install the ground nails (12) to secure the
lamp base to avoid being blown down by wind; b. The
street lamp should be placed in a secure place where it will
not be knocked down.
B. Power-on: Tightly connect the connectors (1) and (4) of
adapter (8) and power wire (10). If the power wire (10) is
not long enough, extended wire (9) between them and then
connect the adapter and main power.
C. Waterproof: If the street lamp will be used outdoors,
please complete the below (see series figures a-e):
a. Please screw the nut at top of lamp holder tightly;
otherwise this will affect the item from being waterproof.
b. All connection points 1 and 2, 3 and 4, 5 and 6, 7 or 8
and lamp holder must be screwed tightly to avoid water
and electricity leakage.
c. The adapter itself is not waterproof, and it is required
that the connecting point between adapter and main
power should be located indoors, free from rain and
snow to avoid the electricity leakage or electric shock
risk.
d. The two ends of lamp support are arranged with drip
hole, and this hole should be unobstructed.
e. The lamp holder should be kept vertical and avoid
inclined to ensure the waterproof effect.
√