Use and Care Guide
2
1) Installation of lamp base and lamp-post
The assembly shall be made from bottom to top, and the
main steps are shown as below:
(see series figures A-F above)
A/B: Use 4 screws to combine the lamp base (13) with
square base (14).
C/D/E: In order to stabilize the street lamp, it is required to
combine with the additional base. Firstly, it is required to
combine 4 pieces of the base trim (11) as a whole, and
then combine the connected base trim (11) with lamp base
(13). Note: If the lamp is used outdoor and the lamp base
can be fixed via ground nail, it will be unnecessary to use
the base trim(11).
F: Installation of lamp post. Screw all lamp posts, connector
of long lamp post and square bases (6), (7), (15) and (14)
according to the sequence shown in above figure. Note:
Each screw thread must be tightly screwed; otherwise the
lamp post will incline or loosen.
2) Combination of lamp support
Fasten two L-shaped supports (2)(20) as a whole via two
firmware (1)(4) according to the figure and description
below:
Place the firmware (front part) (4) on flat surface, with
opening upwards; and then put left and right L-shaped
support (2)(20) in the troughs of firmware (4), and then bury
Y-shaped connection wire (5) and its connector â‘¥
according to the figure, and then use the firmware (rear part)
(1) to cover the above mentioned parts and adjust the
matching state of each part, and finally fasten each part as
a whole lamp support via 6 small screws.
3) Connecting lamp post, lamp support and
lamp holder
(See series figures A -E)
A. Threading: Spear the power wire and its connector (5) in
the lamp base through square base and lamp post (For
convenience, the lamp base and lamp post can be
horizontally or vertically placed upon threading) Draw out
the connector (5) and place it right side up.
B. Assembly of lamp support: Connect the connectors (5)
and (6) of the wires, and put the combined connectors and
their wires into lamp post (6), and then screw the lamp
support and fix it on lamp post (6). Note: it is required to
screw the thread as much as possible and adjust the
direction of lamp support so that its direction is consistent
with that of lamp base.
C. Assembly of lamp holder: Take out of lantern (3) or
(19), and then install it at left (or right) of lamp support
according to individual’s willing, and then insert the plug (7)
(or 8) into the jack at top of lamp holder.
D. Lift the lamp holder upwards so that the upper part of
plug (7) and its connection wire can enter into the hole of
L-shape support, and then turn the nut to let it tightly fit the
thread of the upper part of the lamp holder until the lamp
holder and lamp support become a whole; meanwhile,
notice to adjust the direction of lamp holder until desired.
Note: a. The fixed nut must be tightly screwed, otherwise,
the waterproof effect will be seriously affected. b. The lamp
Assembly Instructions