Use and Care Guide

ManualsBrandsFraser Hill Farm ManualsChristmas Decorations71 in. Double Musical Lamp Post with 2 Red Lanterns and Snow Function

Schematic diagram

Component list

No. Name Quantity

Firmware (rear part)

L-shape support (right)

Lamp holder (right)

1 set

Firmware (front part)

5 Y-shaped connection wire 1 set

Short lamp-post (6.5in)

1 set

Long Lamp-post (17in)

8 Adapter (12V AC 1000mA) 1

9 Extended wire (137in) 1

Power wire (137in)

(

59in lamp-post , 79in out of lamp-post)

11 Base Trim 1 set (4)

12 Ground nail 1 set (4)

13 Lamp base 1

14 Square base 1

15 Connector of long lamp-post (2.5in) 1

16 Brand 1

17 Wreath + bowknot 1 set

18 Lamp pendant 2

19 Lamp holder (left) 1 set

L-shaped support (left)

21 Screw

6+1

（Firmware）

4+1

(Lamp base)

Note: 1,2,3,4,5,6,7,8 are wire connectors

Caution

 This product (especially the lamp holder) is fragile and should be assembled with care.

 This product is waterproof; but it is necessary to keep the lamp in the vertical direction to ensure water drains

correctly.

 Please follow the below steps and requirements specified in the instruction to ensure safety and reliability

during the installation.

Summary of content (4 pages)

PAGE 1
   Caution This product (especially the lamp holder) is fragile and should be assembled with care. This product is waterproof; but it is necessary to keep the lamp in the vertical direction to ensure water drains correctly. Please follow the below steps and requirements specified in the instruction to ensure safety and reliability during the installation. Component list Schematic diagram No.
PAGE 2
Assembly Instructions 1) Installation of lamp base and lamp-post The assembly shall be made from bottom to top, and the main steps are shown as below: 2) Combination of lamp support Fasten two L-shaped supports (2)(20) as a whole via two firmware (1)(4) according to the figure and description below: Place the firmware (front part) (4) on flat surface, with opening upwards; and then put left and right L-shaped support (2)(20) in the troughs of firmware (4), and then bury Y-shaped connection wire (5) and
PAGE 3
holder is fragile, and should be handled with care. c. When there is only one lantern at two ends of lamp support, the lamp post may fall due to being imbalanced; therefore, you should stabilize the lamp post before installation of the second lamp holder. At this time, it will be better to ask another person to assist the installation. Repeat the above mentioned C/D step to complete the installation of the second lamp holder. E.
PAGE 4
D. Examination: The bottom of each lamp holder is arranged with a switch (as shown below). One of the lamp holders can play music, and the music is controlled by its switch (left figure); when the switch is placed on the left. You should be able to see the shining light and snowflakes falling in this lamp holder, with music playing. If the above-mentioned isn’t functioning, check whether all connecting points 1 and 2, 3 and 4, 5 and 6, 7 or 8 are connected well with its lamp holder.