Use and Care Manual

Schematic diagram

Component list

No. Name Number

1 Lamp top 1

2 Lamp holder 1

3 Lamp post (17in） 2

4 Adapter (12V AC 500mA) 1

Extended wire (137in) 1

Power wire (137in)

(inside lamp post: 59in, outside: 78in)

Additional base

1 set

（

4）

Ground nail

Lamp base

Square base

Brand

Lamp post joint

Wreath+ bowknot

1 set

Power wire of lamp holder

Screw

4+1

Note: 1,2,3,4,5,6 are all wire joints.

Caution

 This product (especially the lamp holder) is fragile and should be

assembled with care.

 Please follow the below steps and requirements specified in the

instruction to ensure safety and reliability during the installation.

PAGE 1
  Caution This product (especially the lamp holder) is fragile and should be assembled with care. Please follow the below steps and requirements specified in the instruction to ensure safety and reliability during the installation. Schematic diagram Component list No.
PAGE 2
Assembly Instructions Please assemble the product from the bottom to the up, following the main steps below: 1. Install lamp base A. Assemble lamp base (9) and square base (10) with 4 screws: 3. Install lamp holder A. Lay the lamp post down to thread the power wire (6) and its joint (5) through the lamp base and lamp post. After drawing out the joint (5), place it right side up. B. Assemble connect the 4 pieces of the base trim (7) into a one, and then attach the base trim (7) with the lamp base (9).
PAGE 3
C. Make sure that the connection point between the adapter and the main power source is indoors or at a place free of rain or snow in case of electric leakage or electric shock. All joints of 1, 2, 3 and 4, 5 and 6 must be tightened. D. Examination: When setting the switch on the bottom of the lamp holder (2) (see the figure below) to the left side, the lamp should be lit, snowflakes falling and music playing.