User manual

18 | 19
21. Tandriemafdekkap - linkerzijde
Verwijder het synchronisatiegereedschap en de synchronisatiepen uit het onderste tandwiel.
Plaats de tandriemafdekkap (61) en schroef hem met drie schroeven vast.
21. Cam belt cover - left side
Remove the valve timing tool, and the timing alignment pin from the lower sprocket. Fit the
cam belt cover (61) and secure with three screws.
22. Tandwielen van de verdeleraandrijving
Monteer de kegelwielen van de verdeleraandrijving. Plaats eerst het kleine
krukaswiel C (76). Er zit een groef in die over de uitstulping op de krukas past. Let bij
het plaatsen van het grote tandwiel (69) op de ronde inkeping aan één zijde. Voor
een correcte synchronisatie van de ontsteking, moet dit tandwiel met de platte kant
naar onderen worden geplaatst. Schuif een synchronisatiepen onder het tandwiel
door in de houder op de voorzijde van de krukkast om het tandwiel correct te
positioneren.
22. Distributor drive gears
Install the distributor drive bevel gears. Fit the smaller crankshaft gear C (76) first - it
has a slot that engages with the rib on the crankshaft. When fitting the larger gear
(69), note the round groove in one side. To achieve correct ignition timing, this gear
MUST be installed with the flat section facing downwards as shown. Slide a timing
pin under the gear and into the bracket in the front of the crankcase to ensure the
gear is correctly positioned.