User's Manual

오류! 여기에 표시할 텍스트에 Heading 1 을(를) 적용하려면 [홈] 탭을 사용하십시오. 38
During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency
bands, and placed in positions that simulate RF exposure in usage against, and near the body with the
separation of 5 mm. Although the SAR is determined at the highest certified power level, the actual SAR
level of the while operating can be well below the maximum value. This is because the device is designed
to operate at multiple power levels so as to use only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the lower the power output. Safety and Notices 90
The exposure standard for wireless employs a unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.
Tests for SAR are conducted using standard operating positions accepted by the FCC with the
device transmitting at its highest certified power level in all tested frequency bands.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device
is on file with the FCC and can be found under the Display Grant section of
https://www.fcc.gov/general/fcc-id-search-page after searching on FCC ID: XHG-U772S
More information on the device's SAR can be found from the following FCC website:
https://www.fcc.gov/general/fcc-id-search-page.
While there may be differences between the SAR levels of various devices and at various positions, they
all meet the government requirement.
Body-Worn Operation
Please note this important safety information regarding radio frequency (RF) radiation exposure and near-
body operation. To ensure compliance with RF exposure guidelines, the device must be used at least 5
mm from your body. Failure to observe this warning could result in RF exposure exceeding the applicable
guideline limits.